Pintura plástica mate a base de emulsión acrílico-estirenada. Exterior e interior. Para la protección y decoración de superficies de yeso, cemento, etc.
Características
Nombre del color*
White
Tipo de producto*
Pintura
Forma del producto*
Preparado
Adecuado para uso en exteriores*
Si
Apto para uso en interior*
Si
Mejores usos*
Universal
Localización adecuada*
Universal
Gama de color*
Blanco
Color de la pintura
Blanco
Cobertura de superficie*
12 m²/L
Rendimiento (mín.)
9,5 m²/L
Rendimiento (máx.)
12 m²/L
Tipo final*
Mate
Volumen de pintura*
15 L
Contiene compuestos orgánicos volátiles (COV)
30 g/l
Clase de emisión de compuestos orgánicos volátiles (VOC)
A
Características
Tiempo de secado
0,3 h
Segunda capa después de
3 h
Secado rápido
Si
Lavable
Si
Sin salpicaduras
Si
Tipo de dispensador
Lata
De fácil aplicación
Si
Fácil de usar
Si
Fácil de limpiar
Si
A prueba de agua
Si
Instrucciones de uso
Previous preparation: the surfaces to be painted must be dry and clean of dust, efflorescence, rust, grease, wax, etc. and properly printed. New surfaces Masonry: If you wish to give a first coat to use as a primer, thin the paint with approximately 10-15% water.
Dead or dusty plaster: prime with Brufix Fixing Preparation or Universal Fixer. Iron / Steel: prime with Brumin Antirust Preparation. Wood: prime with Sellatine Wood Preparation or Acrylic Bruguer Universal Preparation. Finish: apply one or two coats of Expert. Respect the drying time between coats. Painted surfaces: If the old paint is in good condition, clean and apply one or two coats of Expert Matte. If the old paint is in poor condition, it must be removed and proceed as on a new surface. If the old paint is glue, tempera or lime it must be removed or at least primed with Brufix Fixing Preparation until a firm support is achieved. For painting other materials or specific situations not contemplated in this Technical Data Sheet,
Observations: On very porous surfaces the first layer can be diluted up to 20-30%. Surfaces affected by tobacco smoke or stains caused by water leaks or infiltrations must be primed with Sellatine Wood Preparation to prevent subsequent bleeding.